In this paper, pressure and shear stress are derived under steady state using one-dimensional analysis of the single-grooved slider bearing and journal bearing with partial slip on the stationary surface. The Reynolds boundary conditions are used in the analysis of journal bearing to predict the extent of the full film region. In the cases of partial slip slider and journal bearing, the pressure distribution is higher compared with the conventional bearing with no slip. In the case of partial slip on both slider and journal bearing surfaces, the single-groove, immediately followed by the partial slip region, results in the increase in pressure distribution. The results also show that in comparison to the conventional bearing with no slip, in the cases of partial slip slider and journal bearing, the shear stress increases before the region of slip/no slip interface, while the shear stress decreases in the region of no slip. In the case of the partial slip region on bearing surfaces, the shear stress distribution is lower in the region immediately after the groove. Significant pressure distribution is obtained due to the influence of partial slip on the slider bearing with uniform film thickness and the concentric journal bearing. The maximum pressure occurs at the end of the region of groove, immediately followed by the region of the partial slip. It is found that the pressure distribution of the slider and journal bearing with partial slip surface are not influenced with the further increase in the nondimensional slip coefficient from 10 to 100.
Skip Nav Destination
e-mail: tvvlnrao@bits-pilani.ac.in
Article navigation
January 2010
Technical Briefs
Analysis of Single-Grooved Slider and Journal Bearing With Partial Slip Surface
T. V. V. L. N. Rao
T. V. V. L. N. Rao
Assistant Professor
Mechanical Engineering Group,
e-mail: tvvlnrao@bits-pilani.ac.in
BITS Pilani
, 333 031 Rajasthan, India
Search for other works by this author on:
T. V. V. L. N. Rao
Assistant Professor
Mechanical Engineering Group,
BITS Pilani
, 333 031 Rajasthan, Indiae-mail: tvvlnrao@bits-pilani.ac.in
J. Tribol. Jan 2010, 132(1): 014501 (7 pages)
Published Online: November 10, 2009
Article history
Received:
December 18, 2008
Revised:
September 12, 2009
Online:
November 10, 2009
Published:
November 10, 2009
Citation
Rao, T. V. V. L. N. (November 10, 2009). "Analysis of Single-Grooved Slider and Journal Bearing With Partial Slip Surface." ASME. J. Tribol. January 2010; 132(1): 014501. https://doi.org/10.1115/1.4000276
Download citation file:
Get Email Alerts
Related Articles
Equivalent Clearance Model for Solving Thermohydrodynamic Lubrication of Slider Bearings With Steps
J. Tribol (May,2017)
Multi-Constrained Optimization of Running Characteristics of Mechanisms Lubricated With Compressible Fluid
J. Tribol (January,2004)
Discussion: “A Mathematical Model for Frictional Elastic-Plastic Sphere-on-Flat Contacts at Sliding Incipient” ( Chang, L., and Zhang, H., 2007, ASME J. Appl. Mech., 74, pp. 100–106 )
J. Appl. Mech (September,2007)
Performance of a Powder Lubricated Journal Bearing With
WS 2 Powder: Experimental Study
J. Tribol (July,1996)
Related Proceedings Papers
Related Chapters
Compressive Deformation of Hot-Applied Rubberized Asphalt Waterproofing
Roofing Research and Standards Development: 10th Volume
Hydrodynamic Lubrication
Design of Mechanical Bearings in Cardiac Assist Devices