In this work computational fluid dynamics (CFD) technique has been used to analyze the detailed flow structures of refrigerant R-134a in an adiabatic capillary tube using volume of fluid based finite volume method. Also, an attempt has been made to understand the flashing phenomenon within the adiabatic capillary tube. A source term has been incorporated in the governing equations to model the mass transfer rate from liquid phase to vapor phase during the flashing process. The developed numerical model has been validated with the available experimental data. The unsteady variations of flow properties such as velocity, void fraction distributions, and flow turbulence across the cross section and at different axial length of the tube have been presented. It has been observed that flashing initiates from the wall of the tube. With the inception of vapor, the flow properties change drastically with very short transient period. As far as flow turbulence is concerned, the role of flashing parameter seems to be stronger than internal tube wall roughness.
Issue Section:
Research Papers
References
1.
Marcy
, G. P.
, 1949
, “Pressure Drop With Change of Phase in a Capillary Tube
,” Refrig. Eng.
, 57
(1
), pp. 53
–57
.2.
Kim
, R. H.
, 1987
, “Computer Aided Design of a Capillary Tube for the Expansion Valve of the Refrigeration Machine
,” ASHRAE Trans., 93
(Part-2), pp. 1362
–1369
.3.
Wong
, T. N.
, and Ooi
, K. T.
, 1996
, “Evaluation of Capillary Tube Performance for CFC-12 and HFC-134a
,” Int. Commun. Heat Mass Transfer
, 23
(7
), pp. 993
–1001
.10.1016/0735-1933(96)00081-44.
Bansal
, P. K.
, and Rupasinghe
, A. S.
, 1998
, “A Homogeneous Model for Adiabatic Capillary Tubes
,” Appl. Therm. Eng.
, 18
(3–4
), pp. 207
–219
.10.1016/S1359-4311(97)00016-15.
Wei
, C. S.
, Lin
, Y. T.
, and Wang
, C. C.
, 2000
, “A Performance Comparison Between Coiled and Straight Capillary Tubes
,” Heat Transfer Eng.
, 21
(2
), pp. 62
–66
.10.1080/0145763002710316.
Liang
, S. M.
, and Wong
, T. N.
, 2001
, “Numerical Modeling of Two-Phase Refrigerant Flow Through Adiabatic Capillary Tubes
,” Appl. Therm. Eng.
, 21
(10
), pp. 1035
–1048
.10.1016/S1359-4311(00)00097-17.
Wongwises
, S.
, and Pirompak
, W.
, 2001
, “Flow Characteristics of Pure Refrigerants and Refrigerant Mixtures in Adiabatic Capillary Tubes
,” Appl. Therm. Eng.
, 21
(8
), pp. 845
–861
.10.1016/S1359-4311(00)00090-98.
Khan
, M. K.
, Kumar
, R.
, and Sahoo
, P. K.
, 2009
, “Flow Characteristics of Refrigerants Flowing Through Capillary Tube
,” Appl. Therm. Eng.
, 29
(8–9
), pp. 1426
–1439
.10.1016/j.applthermaleng.2008.08.0209.
Chingulpitak
, S.
, and Wongwises
, S.
, 2011
, “A Comparison of Flow Characteristics of Refrigerants Flowing Through Adiabatic Straight and Helical Capillary Tubes
,” Int. Commun. Heat Mass Transfer
, 38
(3
), pp. 398
–404
.10.1016/j.icheatmasstransfer.2010.12.01410.
Chen
, S. L.
, Cheng
, Y. R.
, Liu
, C. H.
, and Jwo
, C. S.
, 2000
, “Simulation of Refrigerants Flowing Through Adiabatic Capillary Tubes
,” HVAC&R Res.
, 6
(2
), pp. 101
–115
.10.1080/10789669.2000.1039125211.
Osher
, S.
, and Fedkiw
, R. P.
, 2001
, “Level Set Methods: An Overview and Some Recent Results
,” J. Comput. Phys.
, 169
(2
), pp. 463
–502
.10.1006/jcph.2000.663612.
Hirt
, C. W.
, and Nichols
, B.
, 1981
, “Volume of Fluid (VOF) Method for Dynamics of Free Boundaries
,” J. Comput. Phys.
, 39
(1
), pp. 201
–225
.10.1016/0021-9991(81)90145-513.
Tryggvason
, G.
, Bunner
, B.
, Esmaeeli
, A.
, Juric
, D.
, Al-Rawahi
, N.
, Tauber
, W.
, Han
, J.
, Nas
, S.
, and Jan
, Y. J.
, 2001
, “A Front-Tracking Method for the Computations of Multiphase Flow
,” J. Comput. Phys.
, 169
(2
), pp. 708
–759
.10.1006/jcph.2001.672614.
Tanasawa
, I.
, 1991
, “Advances in Condensation Heat Transfer
,” Advances in Heat Transfer
, Vol. 21
, J. P.
Hartnett
, and T. F.
Irvine
, eds., Academic Press
, San Diego, CA
.15.
Son
, G.
, and Dhir
, V. K.
, 1998
, “Numerical Simulation of Film Boiling Near Critical Pressures With a Level-Set Method
,” ASME J. Heat Transfer
, 120
(1
), pp. 183
–192
.10.1115/1.283004216.
Chen
, W. X.
, Chong
, D. T.
, Yan
, J. J.
, Dong
, S. C.
, and Liu
, J. P.
, 2014
, “Numerical Investigation of Two-Phase Flow in Natural Gas Ejector
,” Heat Transfer Eng.
, 35
(6–8
), pp. 738
–745
.10.1080/01457632.2013.83806917.
Son
, G.
, 2001
, “A Numerical Method for Bubble Motion With Phase Change
,” Num. Heat Transfer B
, 39
(5
), pp. 509
–523
.10.1080/10407790175018886818.
Welch
, S. W. J.
, and Wilson
, J.
, 2000
, “A Volume of Fluid Based Method for Fluid Flows With Phase Change
,” J. Comput. Phys.
, 160
(2
), pp. 662
–682
.10.1006/jcph.2000.648119.
Tanguy
, S.
, Ménard
, T.
, and Berlemont
, A.
, 2007
, “A Level Set Method for Vaporizing Two-Phase Flows
,” J. Comput. Phys.
, 221
(2
), pp. 837
–853
.10.1016/j.jcp.2006.07.00320.
Liu
, Z.
, Sunden
, B.
, and Yuan
, J.
, 2012
, “VOF Modeling and Analysis of Filmwise Condensation Between Vertical Parallel Plates
,” Heat Transfer Res.
, 42
(1
), pp. 47
–68
.10.1615/HeatTransRes.201200437621.
Fang
, C.
, David
, M.
, Rogacs
, A.
, and Goodson
, K.
, 2010
, “Volume of Fluid Simulation of Boiling Two-Phase Flow in a Vapor-Venting Microchannels
,” Frontiers Heat Mass Transfer (FHMT)
, 1
(1), p. 013002
.10.5098/hmt.v1.1.300222.
Bortolin
, S.
, Col
, D. D.
, and Rossetto
, L.
, 2011
, “Flow Boiling of R245fa in a Single Circular Microchannel
,” Heat Transfer Eng.
, 32
(13–14
), pp. 1160
–1172
.10.1080/01457632.2011.56272723.
Mahmoud
, A. M. M.
, Karayiannis
, T. G.
, and Kenning
, D. B. R.
, 2014
, “Flow Boiling Pressure Drop of R134a in Microdiameter Tubes: Experimental Results and Assessment of Correlations
,” Heat Transfer Eng.
, 35
(2
), pp. 178
–192
.10.1080/01457632.2013.81249124.
Kandlikar
, S. G.
, 2010
, “Similarities and Differences Between Flow Boiling in Microchannels and Pool Boiling
,” Heat Transfer Eng.
, 31
(3
), pp. 159
–167
.10.1080/0145763090330433525.
Lee
, W. H.
, 1980
, “A Pressure Iteration Scheme for Two Phase Flow Modeling
,” Multiphase Transport Fundamentals, Reactor Safety, Applications
, Vol. 1
, T. N.
Veziroglu
, ed., Hemisphere Publishing
, Washington, DC
.26.
Yang
, Z.
, Peng
, X. F.
, and Ye
, P.
, 2008
, “Numerical and Experimental Investigation of Two Phase Flow During Boiling in a Coiled Tube
,” Int. J. Heat Mass Transfer
, 51
(5–6
), pp. 1003
–1016
.10.1016/j.ijheatmasstransfer.2007.05.02527.
Tomar
, G.
, Biswas
, G.
, Sharma
, A.
, and Agrawal
, A.
, 2005
, “Numerical Simulation of Bubble Growth in Film Boiling Using a Coupled Level-Set and Volume-of-Fluid Method
,” Phys. Fluids
, 17
(11
), p. 112103
.10.1063/1.213635728.
Prajapati
, Y.
, Khan
, M. K.
, and Pathak
, M.
, 2014
, “Two-Phase VOF Model for the Refrigerant Flow Through Adiabatic Capillary Tube
,” ASHRAE Trans.
, 120
(Part-1
), pp. 60
–67
.29.
Bunner
, B.
, and Tryggvason
, G.
, 2003
, “Effect of Bubble Deformation on the Properties of Bubbly Flows
,” J. Fluid Mech.
, 495
, pp.77
–118
.10.1017/S002211200300629330.
Nierhaus
, T.
, Abeele
, D. V.
, and Deconinck
, H.
, 2007
, “Direct Numerical Simulation of Bubbly Flow in the Turbulent Boundary Layer of a Horizontal Parallel Plate Electrochemical Reactor
,” Int. J. Heat Fluid Flow
, 28
(4
), pp. 542
–551
.10.1016/j.ijheatfluidflow.2007.03.00531.
Lu
, J.
, and Tryggvason
, G.
, 2008
, “Effect of Bubble Deformability in Turbulent Bubbly Upflow in a Vertical Channel
,” Phys. Fluids
, 20
(4
), p. 040701
.10.1063/1.291103432.
Bolotnov
, I. A.
, Jansen
, K. E.
, Drew
, D. A.
, Oberai
, A. A.
, Lahey
, R. T.
, Jr., and Podowski
, M. Z.
, 2011
, “Detached Direct Numerical Simulations of Turbulent Two-Phase Bubbly Channel Flow
,” Int. J. Multiphase Flow
, 37
(6
), pp. 647
–659
.10.1016/j.ijmultiphaseflow.2011.03.00233.
Awad
, M. M.
, and Muzychka
, Y. S.
, 2010
, “Effective Property Models for Homogeneous Two-Phase Flows
,” Exp. Therm. Fluid Sci.
, 33
(1
), pp. 106
–113
.10.1016/j.expthermflusci.2008.07.00634.
Hua
, J.
, Zhang
, B.
, and Lou
, J.
, 2007
, “Numerical Simulation of Microdroplet Formation in Coflowing Immiscible Liquids
,” AIChE J.
, 53
(10
), pp. 2534
–2548
.10.1002/aic.1128735.
Brackbill
, J. U.
, Kothe
, D. B.
, and Zemach
, C.
, 1992
, “A Continuum Method for Modeling Surface Tension
,” J. Comput. Phys.
, 100
(2
), pp. 335
–354
.10.1016/0021-9991(92)90240-Y36.
NIST
, 2010
, REFPROP, Thermodynamic and Transport Properties of Refrigerants and Refrigerant Mixtures. Version 9.0. National Institute of Standards and Technology.37.
Li
, R.-Y.
, Lin
, S.
, Chen
, Z.-Y.
, and Chen
, Z.-H.
, 1990
, “Mestastable Flow of R12 Through Capillary Tubes
,” Int. J Refrig.
, 13
(3
), pp. 181
–186
.10.1016/0140-7007(90)90073-638.
Mikol
, E. P.
, 1963
, “Adiabatic Single and Two-phase Flow in Small Bore Tubes
,” ASHRAE J.
, 5
(11), pp. 75
–86
.Copyright © 2015 by ASME
You do not currently have access to this content.
