Spar platforms with cylindrical shape and constant cross-section area may experience resonant heave motions in sea states with long peak periods, which are probably excessive for riser integrity due to its low damping and relatively low natural heave period. Changes to hull shape and cross-section that produce more benign heave behavior were discussed by some researchers in the past. In this study, the viscous damping of spar structures is explicitly calculated, and incorporated to the potential solution. It is concluded that the heave resonant response can be considerably reduced by alternative hull shapes via increased damping mechanism and the natural heave period being kept outside the range of the wave energy.

1.
Haslum, H. A., and Faltinsen, O. M., 1999, “Alternative Shape of Spar Platforms for Use in Hostile Areas,” Offshore Technology Conference, OTC 10953, Houston, Texas.
2.
Tao, L., Cheng, L. and Thiagarajan, K., 1999, “Numerical estimation of hydrodynamic heave damping of a vertical cylinder with appendages,” Proceedings of the Ninth International Offshore and Polar Engineering Conference, Vol III, 490–495.
3.
Tao
,
L.
,
Thiagarajan
,
K.
, and
Cheng
,
L.
,
2000
, “
On the parametric dependence of springing damping of TLP and Spar columns
,”
Appl. Ocean. Res.
,
22
(
5
), pp.
281
294
.
4.
DNV, 1993, SESAM User’s Manual—WADAM, Det Norske Veritas.
5.
Lee, C.-H., 1995, “WAMIT Theory Manual,” Report 95-2, Dept. of Ocean Engineering, MIT.
6.
Tao, L., 2002, “Numerical investigation of hydrodynamic heave damping of deep water offshore structures,” Ph.D. Thesis, Center for Oil & Gas Engineering, The University of Western Australia.
7.
Thiagarajan, K., Datta, I., Ran, Z., Tao, L., and Halkyard, J., 2002, “Influence of heave plate geometry on the heave response of classic spars,” Proceedings of the 21st International Conference on Offshore Mechanics and Arctic Engineering, OMAE2002-28350, Oslo, Norway.
8.
Graham
,
J. M. R.
,
1980
, “
The Forces on Sharp-edged cylinders in oscillatory flow at low Keulegan-Carpenter numbers
,”
J. Fluid Mech.
,
97
(
1
), pp.
331
346
.
9.
Roddier, D., Liao, S.-W. and Yeung, R. W., 2000, “On Freely-floating Cylinders Fitted with Bilge Keels,” Proceedings of the Tenth International Offshore and Polar Engineering Conference, Vol. III, pp. 377–384.
10.
Roddier, R. W., Liao, S.-W. and Yeung, D., 2000, “On Rll Hydrodynamics of rectangular Cylinders,” Proceedings of the Eighth International Offshore and Polar Engineering Conference, Vol. III, pp. 445–463.
You do not currently have access to this content.