1-6 of 6
Keywords: material removal rate
Close
Sort by
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Manuf. Sci. Eng. April 2024, 146(4): 041005.
Paper No: MANU-23-1520
Published Online: February 26, 2024
... combinations. The results showed that the material removal rate (MRR), reduction of roughness height (σ), and peak curvature radius (ρ) increase were the highest in the initial stage, followed by a slight increase in the real-contact area in the second stage. This research suggests that abrasive particles...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Manuf. Sci. Eng. August 2022, 144(8): 081001.
Paper No: MANU-21-1237
Published Online: February 16, 2022
... interface can be calculated. Combined with the material removal rate model, the continuous evolution process of the workpiece and lapping plate can be predicted in the lapping process. The modeling method was validated by a lapping test of a flat optical glass workpiece (Φ 100 mm) with a composite copper...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Manuf. Sci. Eng. December 2018, 140(12): 121015.
Paper No: MANU-18-1355
Published Online: October 8, 2018
... to the complicated cutter-workpiece engagement (CWE) of bull-nose end cutter in five-axis milling, the maximal cutting depth may not produce the maximal material removal rate (MRR). Thus, the traditional stability analysis is not suitable for the five-axis bull-nose end milling in parameters optimization...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Manuf. Sci. Eng. February 2015, 137(1): 011015.
Paper No: MANU-14-1110
Published Online: February 1, 2015
... failures [ 2 , 3 ]. volumetric tool wear wear rate grain size material removal rate turning carbide Ti–6Al–4V M-ratio The objective of this paper is to analyze the effect of different carbide grain sizes on the tool material volume worn away from straight tungsten–carbide–cobalt (WC–Co...
Journal Articles
Journal Articles