Abstract
Undetected roof leaks and the subsequent deterioration are considered one of the primary causes of premature roof failure. This paper shows the need for a systematic procedure to test, verify, and monitor the integrity of roofing and waterproof membranes using low voltage electrical conductance measurement methods to locate leaks in membranes. The methods described are particularly useful for roof designs that incorporate a membrane under a vegetative, wear-course, or topping slab where direct inspection of the membrane is difficult or impossible.
Issue Section:
Research Papers
References
1.
Bailey
, D. M.
, Ditmar
, J.
, Dupuis
, R.
, and Buckner
, A.
, “Survey of Passive Leak Location Technologies
,” USACERL Technical Report FM-94/04, U.S. Army Corp of Engineers Construction Engineering Research Laboratories.2.
Liu
, K. Y.
, and Baskaran
, A.
, “Using Garden Roof Systems to Improve Performance
,” NRCC-48376, National Research Council Canada.3.
Consiglio
, G. C.
, “Foreword: The Challenge
,” Building Science Insight’89, “Roofs that Work,” NRCC 31512, Ottawa, October 1989
.4.
Lounis
, Z.
, Vanier
, D. J.
, and Lacasse
, M. A.
, “A Discrete Stochastic Model For Performance Prediction Of Roofing Systems
,” CIB World Building Congress, “Construction and the Environment
,” Gävle
, Sweden
, June 7–12, 1998
.5.
Hensley
, L.
, “Sweeping Deck Joints Under the Rug
,” Structural Engineer
, Vol. 7
, No. 4
, May 2006
, pp. 38
–39
.6.
Hedlin
, C. P.
, “Inspection and Maintenance of Flat Roofs
,” CBD-179, Canadian Building Digest, 1976
.7.
Mendel
, B.
, “Anatomy of a Plaza Deck
,” FOCUS, CAI, Greater Los Angeles Chapter, May/June 2006
.8.
Canadian Roofing Contractors′ Association Association Canadienne Des Entrepreneurs En Couverture, Advisory Bulletin March
2007
.9.
Vokey
, D.
and Teetart
, J.
, (2006, summer). “A Building Envelope Moisture Detection System Using Contiguous Zone Monitoring
,” Ontario Building Envelope Council Publication, Summer 2006
, pp. 25
–27
.10.
Echholn
, C.
, “Electric Field Vector Mapping
,” RCI, Technical Journal, June 2002, pp 3–7.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.