Issue Section:
Technical Briefs
Keywords:
Flow Separation, Forced Convection, Numerical Methods
Topics:
Entrance region, Forced convection, Flow separation, Numerical analysis
1.
Abdel-Rahman, A. K., Suzuki, K., Hagiwara, Y., and Takaura, H., 1991, “Laminar Channel Flow With Fluid Injection Accounting for the Flow in the Porous Wall,” Proc. 28th National Heat Transfer Symposium of Japan, pp. 406–408.
2.
Chou
 
F. C.
, and
Hwang
 
G. J.
,
1987
, “
Vorticity-Velocity Method for the Graetz Problem and the Effect of Natural Convection in a Horizontal Rectangular Channel With Uniform Wall Heat Flux
,”
ASME JOURNAL OF HEAT TRANSFER
, Vol.
109
, pp.
704
–
710
.
3.
Eckert, E. R. G., Donoughe, P. L., and Moore, B. J., 1957, “Velocity and Friction of Laminar Viscous Boundary-Layer and Channel Flow Over Surfaces With Injection or Suction,” NACA TN 4102.
4.
Farouk
 
B.
, and
Fusegi
 
T.
,
1986
, “
Predictions of Fluid and Heat Transfer Problems by the Vorticity-Velocity Formulation of the Navier-Stokes Equations
,”
J. Comp. Phys.
, Vol.
65
, pp.
227
–
243
.
5.
Hwang
 
G. J.
,
Cheng
 
Y. C.
, and
Ng
 
M. L.
,
1993
, “
Developing Laminar Flow and Heat Transfer in a Square Duct With One-Walled Injection and Suction
,”
Int. J. Heat Mass Transfer
, Vol.
36
, No.
9
, pp.
2429
–
2440
.
6.
Jen
 
T. C.
,
Lavine
 
A. S.
, and
Hwang
 
G. J.
,
1992
, “
Simultaneously Developing Laminar Convection in Rotating Isothermal Square Channels
,”
Int. J. Heat Mass Transfer
, Vol.
35
, No.
1
, pp.
239
–
254
.
7.
Jen
 
T. C.
,
1994
, “
Simultaneously Developing Laminar Convection in the Entrance Region of a Semi-porous Channel
,”
Current Development in Numerical Simulation of Flow and Heat Transfer
, ASME HTD-Vol.
275
, pp.
111
–
122
.
8.
Moskowitz
 
S. L.
, and
Lombardo
 
S.
,
1971
, “
2750 Deg F Engine Turbine Test of a Transpiration Air–Cooled Turbine
,”
ASME Journal of Engineering for Gas Turbines and Power
, Vol.
93
, pp.
238
–
248
.
9.
Patankar, S. V., 1980, Numerical Heat Transfer and Fluid Flow, Hemisphere Publishing Co., pp. 96–100.
10.
Raithby
 
G.
,
1971
, “
Laminar Heat Transfer in the Thermal Entrance Region of Circular Tubes and Two-Dimensional Rectangular Ducts With Wall Suction and Injection
,”
Int. J. Heat Mass Transfer
, Vol.
14
, pp.
224
–
243
.
11.
Raithby
 
G. D.
, and
Knudsen
 
D. C.
,
1974
, “
Hydrodynamic Development in a Duct With Suction and Blowing
,”
J. Appl. Mech.
, Vol.
41
, pp.
896
–
902
.
12.
Raj
 
R.
,
1983
, “
Deposition Results of a Transpiration Air–Cooled Turbine Vane Cascade in a Contaminated Gas Stream
,”
ASME Journal of Engineering for Gas Turbines and Power
, Vol.
105
, pp.
826
–
833
.
13.
Rhee
 
S. J.
, and
Edwards
 
D. K.
,
1981
, “
Laminar Entrance Flow in a Flat Plate Duct With Asymmetric Suction and Heating
,”
Num. Heat Transfer
, Vol.
4
, pp.
85
–
100
.
14.
Soong
 
C. Y.
, and
Hwang
 
G. J.
,
1990
, “
Laminar Mixed Convection in a Radially Rotating Semiporous Channel
,”
Int. J. Heat Mass Transfer
, Vol.
33
, No.
9
, pp.
1805
–
1816
.
This content is only available via PDF.
Copyright © 1996
 by The American Society of Mechanical Engineers

Article PDF first page preview

Article PDF first page preview
You do not currently have access to this content.