Skip Nav Destination
Article navigation
May 2018
Errata
Erratum: “Static Performance Characteristics and Rotordynamic Coefficients for a Four-Pad Ball-in-Socket Tilting Pad Journal Bearing” [ASME J. Eng. Gas Turbines Power, 2009, 131(6), p. 062502; DOI: 10.1115/1.3098376]
J. Eng. Gas Turbines Power. May 2018, 140(5): 057001 (1 pages)
Published Online: December 19, 2017
Article history
Received:
September 14, 2017
Revised:
October 24, 2017
Connected Content
Citation
Harris, J., and Childs, D. (December 19, 2017). "Erratum: “Static Performance Characteristics and Rotordynamic Coefficients for a Four-Pad Ball-in-Socket Tilting Pad Journal Bearing” [ASME J. Eng. Gas Turbines Power, 2009, 131(6), p. 062502; DOI: 10.1115/1.3098376]." ASME. J. Eng. Gas Turbines Power. May 2018; 140(5): 057001. https://doi.org/10.1115/1.4038615
Download citation file:
174
Views
Get Email Alerts
Cited By
Foreign Object Damage of Environmental Barrier Coatings Subjected to CMAS Attack
J. Eng. Gas Turbines Power
Generative deep learning on images of thermo-mechanical simulation results
J. Eng. Gas Turbines Power
Related Articles
A Journal Bearing With Variable Geometry for the Reduction of the Maximum Amplitude During Passage Through Resonance
J. Vib. Acoust (December,2012)
Tilting Pad Journal Bearing Misalignment Effect on Thermally Induced Synchronous Instability (Morton Effect)
J. Tribol (March,2021)
Nonlinear Effects of Surface Texturing on the Performance of Journal Bearings in Flexible Rotordynamic Systems
J. Tribol (September,2017)
Comparative Analysis of Off-Design Performance Characteristics of Single and Two-Shaft Industrial Gas Turbines
J. Eng. Gas Turbines Power (October,2003)
Related Proceedings Papers
Related Chapters
Experimental and Statistical Study on the Noise Generated by Surface Defects of Bearing Rolling Bodies
Bearing and Transmission Steels Technology
Introduction I: Role of Engineering Science
Fundamentals of heat Engines: Reciprocating and Gas Turbine Internal Combustion Engines
Introduction and Definitions
Handbook on Stiffness & Damping in Mechanical Design