In this two-part series publication a mathematical model of the energy conversion process in a diesel engine based combined-cycle power plant has been developed and verified. The examined configuration consists of a turbocharged diesel engine (the topping cycle), a heat recovery steam generator (HRSG) and a steam turbine plant (the bottoming cycle). The model is then used to provide an analysis of performance characteristics of the combined-cycle power plant for steady-state operation. Numerous practical performance parameters of interest have been generated, such as the mean indicated pressure, specific fuel consumption, hourly fuel consumption, brake horsepower of diesel engine, mass flow rate, pressure, and temperature of gases and air, respectively, through the gas turbine and compressor (in the frame of a turbocharger), temperature of flue gases at boiler inlet and outlet, mass flow rate of exhaust gases through the convection coils, and mass flow rate, temperature, pressure, and enthalpy of superheated steam. The performance maps have been derived. The effect of change in the major operating variables (mutual operation of diesel engine, HRSG, and steam turbine) has been analyzed over a range of operating conditions, including the engine load and speed. The model is used as a desktop design tool for accurate predictions of cycle performance, as well as insight into design trends.
Skip Nav Destination
Article navigation
January 2004
Technical Papers
Modeling the Performance Characteristics of Diesel Engine Based Combined-Cycle Power Plants—Part II: Results and Applications
Stan N. Danov,
Stan N. Danov
Fluor Canada, Inc., 55 Sunpark Plaza, SE, Calgary, AL T2X 3R4, Canada
Search for other works by this author on:
Ashwani K. Gupta
Ashwani K. Gupta
Department of Mechanical Engineering, University of Maryland, College Park, MD 20742
Search for other works by this author on:
Stan N. Danov
Fluor Canada, Inc., 55 Sunpark Plaza, SE, Calgary, AL T2X 3R4, Canada
Ashwani K. Gupta
Department of Mechanical Engineering, University of Maryland, College Park, MD 20742
Contributed by the Fuels and Combustion Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received by the F&C Division April 2002; final revision received February 2003. Associate Editor: S. Gollahalli.
J. Eng. Gas Turbines Power. Jan 2004, 126(1): 35-39 (5 pages)
Published Online: March 2, 2004
Article history
Received:
April 1, 2002
Revised:
February 1, 2003
Online:
March 2, 2004
Citation
Danov, S. N., and Gupta, A. K. (March 2, 2004). "Modeling the Performance Characteristics of Diesel Engine Based Combined-Cycle Power Plants—Part II: Results and Applications ." ASME. J. Eng. Gas Turbines Power. January 2004; 126(1): 35–39. https://doi.org/10.1115/1.1635397
Download citation file:
Get Email Alerts
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Modeling the Performance Characteristics of Diesel Engine Based Combined-Cycle Power Plants—Part I: Mathematical Model
J. Eng. Gas Turbines Power (January,2004)
Importance of Auxiliary Power Consumption for Combined Cycle Performance
J. Eng. Gas Turbines Power (April,2011)
Degradation Effects on Combined Cycle Power Plant Performance—Part III: Gas and Steam Turbine Component Degradation Effects
J. Eng. Gas Turbines Power (April,2004)
Combined Cycles With CO 2 Capture: Two Alternatives for System Integration
J. Eng. Gas Turbines Power (June,2010)
Related Chapters
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
Scope
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Performance Testing of Combined Cycle Power Plant
Handbook for Cogeneration and Combined Cycle Power Plants, Second Edition