This paper uses the HCT (hydrodynamics, chemistry and transport) chemical kinetics code to analyze natural gas combustion in an HCCI engine. The HCT code has been modified to better represent the conditions existing inside an engine, including a wall heat transfer correlation. Combustion control and low power output per displacement remain as two of the biggest challenges to obtaining satisfactory performance out of an HCCI engine, and these challenges are addressed in this paper. The paper considers the effect of natural gas composition on HCCI combustion, and then explores three control strategies for HCCI engines: DME (dimethyl ether) addition, intake heating and hot EGR addition. The results show that HCCI combustion is sensitive to natural gas composition, and an active control may be required to compensate for possible changes in composition. Each control strategy has been evaluated for its influence on the performance of an HCCI engine.

1.
Suzuki, H., Koike, N., Ishii, H., and Odaka, M., 1997, “Exhaust Purification of Diesel Engines by Homogeneous Charge with Compression Ignition Part 1: Experimental Investigation of Combustion and Exhaust Emission Behavior Under Pre-Mixed Homogeneous Charge Compression Ignition Method,” SAE paper 970313.
2.
Onishi, S., Jo, S. H., Shoda, K., Jo, P. D., and Kato, S., 1979, “Active Thermo-Atmosphere Combustion (ATAC)—A New Combustion Process for Internal Combustion Engines,” SAE paper 790501.
3.
Noguchi, M., Tanaka, Y., Tanaka, T., and Takeuchi, Y., 1979, “A Study on Gasoline Engine Combustion by Observation of Intermediate Reactive Products During Combustion,” SAE paper 790840.
4.
Ishibashi, Y., and Asai, M., 1996, “Improving the Exhaust Emissions of Two-Stroke Engines by Applying the Activated Radical Concept,” SAE paper 960742.
5.
Ishibashi, Y., and Asai, M., 1998, “A Low Pressure Pneumatic Direct Injection Two-Stroke Engine by Activated Radical Combustion Concept,” SAE paper 980757.
6.
Najt, P. M., and Foster, D. E., 1983, “Compression-Ignited Homogeneous Charge Combustion,” SAE paper 830264.
7.
Smith, J. R., Aceves, S. M., Westbrook, C. and Pitz, W., 1997, “Modeling of Homogeneous Charge Compression Ignition (HCCI) of Methane,” Proceedings of the 1997 ASME Internal Combustion Engine Fall Technical Conference, paper No. 97-ICE-68, ICE-Vol. 29-3, pp. 85–90.
8.
Willand, J., Nieberding, R.-G., Vent, G., and Enderle, C., 1998, “The Knocking Syndrome—Its Cure and Potential,” SAE paper 982483.
9.
Amsden, A. A., 1993, “KIVA-3: A KIVA Program with Block-Structured Mesh for Complex Geometries,” Los Alamos National Laboratory Report LA-12503-MS.
10.
Miyamoto, T., Hayashi, A. K., Harada, A., Sasaki, S., Hisashi, A., and Tujimura, K., 1999, “A Computational Investigation of Premixed Lean Diesel Combustion,” SAE paper 1999-01-0229.
11.
Christensen, M., Johansson, B., Amneus, P., and Mauss, F., 1998, “Supercharged Homogeneous Charge Compression Ignition,” SAE paper 980787.
12.
Aceves, S., Smith, J. R., Westbrook, C, and Pitz, W., 1999, “Compression Ratio Effect on Methane HCCI Combustion,” ASME Journal of Gas Turbines and Power, Vol. 121, No. 3, July 1999.
13.
Lund, C. M., 1978 “HCT—A General Computer Program for Calculating Time-Dependent Phenomena Involving One-Dimensional Hydrodynamics, Transport, and Detailed Chemical Kinetics,” Lawrence Livermore National Laboratory Report UCRL-52504.
14.
Westbrook, C. K., Pitz, W. J., and Leppard, W. R., 1991, “The Autoignition Chemistry of Paraffinic Fuels and Pro-Knock and Anti-Knock Additives: A Detailed Chemical Kinetic Study,” SAE paper 912314.
15.
Pitz, W. J., Westbrook, C. K., and Leppard, W. R., 1991, “Autoignition Chemistry of C4 Olefins Under Motored Engine Conditions: A Comparison of Experimental and Modeling Results,” SAE paper 912315.
16.
Westbrook, C. K., Warnatz, J., and Pitz, W. J., 1988, “A Detailed Chemical Kinetic Reaction Mechanism for the Oxidation of iso-Octane and n-Heptane over an Extended Temperature Range and its Application to Analysis of Engine Knock,” Twenty-Second Symposium (International) on Combustion, p. 893, The Combustion Institute, Pittsburgh.
17.
Curran, H. J., Gaffuri, P., Pitz, W. J., Westbrook, C. K., and Leppard, W. R., 1995, “Autoignition Chemistry of the Hexane Isomers: An Experimental and Kinetic Modeling Study,” SAE paper 952406.
18.
Heywood, J. B., 1988, Internal Combustion Engine Fundamentals, McGraw-Hill, New York.
19.
Woschni, G., 1967, “Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine,” SAE paper 670931.
20.
Curran
,
H. J.
,
Pitz
,
W. J.
,
Marinov
,
N. M.
, and
Westbrook
,
C. K.
, 1997, “
A Wide Range Modeling Study of Dimethyl Ether Oxidation
,”
International Journal of Chemical Kinetics
, Vol.
30
, No.
3
, pp.
229
241
, March
1998
.
21.
Frenklach, M., Wang, H., Goldenberg, M., Smith, G. P., Golden, D. M., Bowman, C. T., Hanson, R. K., Gardiner, W. C., and Lissianski, V., 1995, “GRI-Mech—An Optimized Detailed Chemical Reaction Mechanism for Methane Combustion,” GRI Topical Report No. GRI-95/0058.
22.
Liss, W. E., Thrasher, W. H., Steinmetz, G. F., Chowdiah, P., and Attari, A., 1992, “Variability of Natural Gas Composition in Select Major Metropolitan Areas of the United States,” GRI Report No. GRI-92/0123.
23.
Christensen, M., and Johansson, B, 1998, “Influence of Mixture Quality on Homogeneous Charge Compression Ignition,” SAE paper 982454.
You do not currently have access to this content.