The paper shows the results of an experimental campaign conducted in the CPRTF (Cavitating Pump Rotordynamic Test Facility) at ALTA S.p.A., aimed at characterizing the cavitation thermal effects on two tapered-hub, variable-pitch inducers, designated as DAPAMITO. The semiempirical method proposed by Ruggeri and Moore for scaling the thermal cavitation effects has been successfully applied and consequently, a further validation of this method has been provided. The influence of the temperature on the intensity of the performance degradation associated with the attached cavitation instability has been identified as a new typology of cavitation thermal effects. In this case, the inhibition of the bubble growth due to thermal effects can be detected by the reduction of the performance degradation usually associated with this type of instability.

References

1.
Balje
,
O. E.
, 1981,
Turbomachines. A Guide to Design, Selection and Theory
,
John Wiley
,
New York
.
2.
Brennen
,
C. E.
, 1994,
Hydrodynamics of Pumps
,
Concepts ETI, Inc. and Oxford University Press
,
Oxford
.
3.
Zoladz
,
T.
, 2000, “
Observations on Rotating Cavitation and Cavitation Surge from the Development of the Fastrac Engine Turbopump
,” 36th AIAA/ASME/SAE/ASEE Joint Propulsion Conference, Huntsville, USA.
4.
Yoshida
,
Y.
,
Kikuta
,
K.
,
Watanabe
,
M.
,
Hashimoto
,
T.
,
Nagaura
,
K.
, and
Ohira
,
K.
, 2006, “
Thermodynamic Effect on Cavitation Performances and Cavitation Instabilities in an Inducer
,” CAV2006, 6th Int. Symposium on Cavitation, Wageningen, The Netherlands.
5.
Yoshida
,
Y.
,
Sasao
,
Y.
,
Okita
,
K.
,
Hasegawa
,
S.
,
Shimagaki
,
M.
, and
Nakamura
,
N.
, 2006, “
Influence of Thermodynamic Effect on Synchronous Rotating Cavitation
,” CAV2006, 6th Int.
Symposium on Cavitation, Wageningen
,
The Netherlands
.
6.
Horiguchi
,
H.
,
Arai
,
S.
,
Fukutomi
,
J.
,
Nakase
,
Y.
, and
Tsujimoto
,
Y.
, 2003, “
Quasi Three-Dimensional Analysis of Cavitation in an Inducer
,”
4th ASME-JSME Joint Fluids Engineering Conference
,
Honolulu, Hawaii, USA
, July 6–10.
7.
Stahl
,
H. A.
, and
Stepanoff
,
A. J.
, 1956, “
Thermodynamic Aspects of Cavitation in Centrifugal Pumps
,”
Trans. ASME
,
78
, pp.
1691
1693
.
8.
Ruggeri
,
R. S.
, and
Moore
,
R. D.
, 1969, “
Method for Prediction of Pump Cavitation Performance for Various Liquids, Liquid Temperatures, and Rotative Speeds
,” NASA TN D-5292.
9.
Fruman
,
D. H.
, 2002, “
Review of Thermal Effects in the Cavitation of Inducers
.”
4th International Conference on Launcher Technology
,
Liege, Belgium
, December 3–6.
10.
Rapposelli
,
E.
,
Cervone
,
A.
, and
d’Agostino
,
L.
, 2002, “
A New Cavitating Pump Rotordynamic Test Facility
,” AIAA Paper 2002-4285,
Proc. 38th AIAA/ASME/SAE/ASEE Joint Propulsion Conference
,
Indianapolis, USA
.
11.
d’Agostino
,
L.
,
Torre
,
L.
,
Pasini
,
A.
, and
Cervone
,
A.
, 2008, “
On the Preliminary Design and Noncavitating Performance of Tapered Axial Inducers
,”
ASME J. Fluids Eng.
,
130
(
11
), p.
111303
.
12.
d’Agostino
,
L.
,
Torre
,
L.
,
Pasini
,
A.
,
Baccarella
,
D.
,
Cervone
,
A.
and
Milani
,
A.
, 2008, “
A Reduced Order Model for Preliminary Design and Performance Prediction of Tapered Inducers: Comparison with Numerical Simulations
,”
Proc. 44th AIAA/ASME/SAE/ASEE Joint Propulsion Conference
,
Hartford, USA
.
13.
Moore
,
R. D.
, 1970, “
Prediction of Pump Cavitation Performance
”, Vol.
II
, NASA SP-304,
Pennsylvania State University
.
14.
Shimagaki
,
M.
,
Hashimoto
,
T.
,
Watanabe
,
M.
,
Hasegawa
,
S.
,
Nakamura
,
N.
, and
Shimura
,
T.
, 2006, “
Unsteady Pressure Fluctuations in an Inducer
,”
JSME Int. J. Fluids Thermal Eng, Ser B
,
49
(
3
), pp.
806
811
.
15.
Zocco
,
A.
,
Malagnino
,
G.
,
Motta
,
M.
, and
Munari
,
A.
, 1995, “
Experimental Investigation on Radial Loads Induced by Partial Cavitation on Liquid Oxygen Turbopump Inducer of the Ariane 5 Vulcain Engine
,”
CAV1995, International Symposium on Cavitation
,
Deauville, France
.
You do not currently have access to this content.