A new flow simulation methodology (FSM) for computing turbulent shear flows is presented. The development of FSM was initiated in close collaboration with C. Speziale (then at Boston University). The centerpiece of FSM is a strategy to provide the proper amount of modeling of the subgrid scales. The strategy is implemented by use of a “contribution function” which is dependent on the local and instantaneous “physical” resolution in the computation. This physical resolution is obtained during the actual simulation by comparing the size of the smallest relevant scales to the local grid size used in the computation. The contribution function is designed such that it provides no modeling if the computation is locally well resolved so that the computation approaches a direct numerical simulation in the fine grid limit, or provides modeling of all scales in the coarse grid limit and thus approaches an unsteady RANS calculation. In between these resolution limits, the contribution function adjusts the necessary modeling for the unresolved scales while the larger (resolved) scales are computed as in traditional large-eddy simulations (LES). However, a LES that is based on the present strategy is distinctly different from traditional LES in that the required amount of modeling is determined by physical considerations, and that state-of-the-art turbulence models (as developed for Reynolds-averaged Navier-Stokes) can be employed for modeling of the unresolved scales. Thus, in contrast to traditional LES based on the Smagorinsky model, with FSM a consistent approach (in the local sense) to the coarse grid and fine grid limits is possible. As a consequence of this, FSM should require much fewer grid points for a given calculation than traditional LES or, for a given grid size, should allow computations for larger Reynolds numbers. In the present paper, the fundamental aspects of FSM are presented and discussed. Several examples are provided. The examples were chosen such that they expose, on the one hand, the inherent difficulties of simulating complex wall bounded flows, and on the other hand demonstrate the potential of the FSM approach.
Skip Nav Destination
Article navigation
December 2002
Technical Papers
A Methodology for Simulations of Complex Turbulent Flows
H. F. Fasel,
H. F. Fasel
Department of Aerospace and Mechanical Engineering, The University of Arizona, 1130 N. Mountain, Tucson, AZ 85721-0119
Search for other works by this author on:
J. Seidel,
J. Seidel
Department of Aerospace and Mechanical Engineering, The University of Arizona, 1130 N. Mountain, Tucson, AZ 85721-0119
Search for other works by this author on:
S. Wernz
S. Wernz
Department of Aerospace and Mechanical Engineering, The University of Arizona, 1130 N. Mountain, Tucson, AZ 85721-0119
Search for other works by this author on:
H. F. Fasel
Department of Aerospace and Mechanical Engineering, The University of Arizona, 1130 N. Mountain, Tucson, AZ 85721-0119
J. Seidel
Department of Aerospace and Mechanical Engineering, The University of Arizona, 1130 N. Mountain, Tucson, AZ 85721-0119
S. Wernz
Department of Aerospace and Mechanical Engineering, The University of Arizona, 1130 N. Mountain, Tucson, AZ 85721-0119
Contributed by the Fluids Engineering Division for publication in the JOURNAL OF FLUIDS ENGINEERING. Manuscript received by the Fluids Engineering Division March 29, 2002; revised manuscript received August 12, 2002. Associate Editor: G. E. Karniadakis.
J. Fluids Eng. Dec 2002, 124(4): 933-942 (10 pages)
Published Online: December 4, 2002
Article history
Received:
March 29, 2002
Revised:
August 12, 2002
Online:
December 4, 2002
Citation
Fasel , H. F., Seidel , J., and Wernz, S. (December 4, 2002). "A Methodology for Simulations of Complex Turbulent Flows ." ASME. J. Fluids Eng. December 2002; 124(4): 933–942. https://doi.org/10.1115/1.1517569
Download citation file:
Get Email Alerts
Switching Events of Wakes Shed From Two Short Flapping Side-by-Side Cylinders
J. Fluids Eng (May 2025)
Related Articles
Alternative LES and Hybrid RANS/LES for Turbulent Flows
J. Fluids Eng (December,2002)
Numerical Simulations of Turbulent Mixing and Autoignition of Hydrogen Fuel at Reheat Combustor Operating Conditions
J. Eng. Gas Turbines Power (April,2012)
Computational Evaluation of the Periodic Performance of a NACA 0012 Fitted With a Gurney Flap
J. Fluids Eng (March,2002)
Large Eddy Simulation for Incompressible Flows: An Introduction. Scientific Computation Series
Appl. Mech. Rev (November,2002)
Related Proceedings Papers
Related Chapters
Assessment of Flow Aggressiveness at an Ultrasonic Horn Cavitation Erosion Test Device by PVDF Pressure Measurements and 3D Flow Simulations
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Intelligent Traffic Flow Simulation on a Small Scale Environment
International Conference on Computer and Electrical Engineering 4th (ICCEE 2011)
Exploration of Cavitation-Induced Erosion Metrics in Throttle Flow Simulations
Proceedings of the 10th International Symposium on Cavitation (CAV2018)