Measurements of pressure losses in a U-type undulated hydraulically smooth wall pipe, having constant radius curvature, are presented. The effect of the dimensionless curvature radius 2R/d on the Darcy friction factor was investigated in the range of the Reynolds number from about 50 to 10,000 and for the dimensionless pipe curvature radiuses 2R/d=6.62, 7.95, 11.13, 16.03, 22.58, and 27.85. A smooth transition from laminar to turbulent region in the friction factor versus Reynolds number plot, typical for curved pipe flows, was observed. The experimental data were correlated with the relatively simple equation using new Dean number Den=Re*(Den=Re*d/2R:lnfw*Re/64=a+blnDen2, which is not valid for larger values of Den and 2R/d, e.g., for Den>200 at 2R/d=22.58, and for Den>70 at 2R/d=27.85. The new Dean number, below which the influence of the pipe curvature in comparison to the straight tube was not seen, is Den⩽∼3.[S0098-2202(00)02802-9]

Issue Section:
Technical Papers
Keywords:
pipe flow, laminar to turbulent transitions, friction, pressure measurement
Topics:
Friction, Pipe flow, Pipes, Pressure, Turbulence, Reynolds number
1.
Ward-Smith, A. J., 1980, Internal Fluid Flow. The Fluid Dynamics of Flow in Pipes and Ducts. Chapter B: Bends, Clarendon Press, Oxford, pp. 248–306.
2.
Burger
,
S. A.
,
Talbot
,
L.
, and
Yao
,
L. S.
,
1983
, “
Flow in Curved Pipes
,”
Annu. Rev. Fluid Mech.
,
15
, pp.
461
–
512
.
3.
Ito
,
H.
,
1987
, “
Flow in Curved Pipes
,”
Int. J. JSME
,
30
, pp.
543
–
552
.
4.
Dean
,
W. R.
,
1927
, “
Note on the Motion on Fluid in a Curved Pipe
,”
Philos. Mag.
,
4
, pp.
208
–
223
.
5.
Cheng
,
K. C.
, and
Yuen
,
F. P.
,
1987
, “
Flow Visualization Studies on Secondary Flow Patterns in Straight Tubes Downstream of a 180 deg Bend and in Isothermally Heated Horizontal Tubes
,”
ASME J. Heat Transfer
,
109
, pp.
49
–
54
.
6.
Ito
,
H.
,
1960
, “
Pressure Losses in Smooth Pipe Bends
,”
ASME J. Basic Eng.
,
82
, pp.
131
–
143
.
7.
Shimizu
,
Y.
,
Sugino
,
K.
,
Kuzuhara
,
S.
, and
Murakami
,
M.
,
1982
, “
Hydraulic Losses and Flow patterns in Bent Pipes (Comparison of the Results in Wavy Pipes and Quasi-Coiled Ones)
,”
Bull. JSME
,
25
, pp.
24
–
31
.
8.
Popiel
,
C. O.
, and
Van der Merwe
,
D. F.
,
1996
, “
Friction Factor in Sine-Pipe Flow
,”
ASME J. Fluids Eng.
,
118
, pp.
341
–
345
.
9.
Popiel
,
C. O.
, and
Wojtkowiak
,
J.
,
1998
, “
Simple Formulas for Thermophysical Properties of Liquid Water for Heat Transfer Calculations (from 0°C to 150°C)
,”
Heat Transfer Eng.,
An International Quarterly,
19
, pp.
87
–
101
.
10.
Moffat
,
R. J.
,
1988
, “
Describing the Uncertainties in Experimental Results
,”
Exp. Therm. Fluid Sci.
,
1
, pp.
3
–
17
.
11.
Shah, R. K., and Joshl, S. D., 1987, “Convective Heat Transfer in Curved Ducts,” Handbook of Single-Phase Convective Heat Transfer, p. 5.8, Wiley.
Copyright © 2000
 by ASME
You do not currently have access to this content.