0
RESEARCH PAPERS

Critical Accumulated Strain Energy (Case) Failure Criterion for Thermal Cycling Fatigue of Solder Joints

[+] Author and Article Information
Tsung-Yu Pan

Ford Motor Company, Ford Research Laboratory, 20,000 Rotunda Drive, P.O. Box 2053, Mail Drop 2313, Dearborn, MI 48121-2053

J. Electron. Packag 116(3), 163-170 (Sep 01, 1994) (8 pages) doi:10.1115/1.2905681 History: Received October 04, 1992; Revised May 10, 1994; Online April 28, 2008

Abstract

In the automotive and computer industries, a perennial challenge has been to design an adequate and efficient accelerated thermal cycling test which would correspond to field service conditions. Failures, induced in both thermal cycle testing and field service, are characterized by thermal fatigue behavior. Several fatigue models have been proposed, none of these models take into account all of the many parameters of the test or service environment. In thermal cycling, for example, the temperature range, ramp rate, hold time, and stepped heating and cooling are known to influence the number of cycles to failure. In this study, a c ritical a ccumulated s train e nergy (CASE) failure criterion is proposed to correlate the fatigue life to both the plastic and creep strain energies, which accumulate in solder joints during the thermal cycling. This criterion suggests that solder joints fail as the strain energy accumulates and reaches a critical value. By using finite element analysis with a “ladder” procedure, both time-independent plastic strain energy and time-dependent creep strain energy are quantified. These are related to fatigue life by the equation: C = N*f (Ep + 0.13Ec ), where C is the critical strain energy density, Nf is the fatigue life, Ep and Ec are plastic and creep strain energy density accumulation per cycle, respectively, for the eutectic Sn-Pb solders. By analyzing Hall and Sherry’s thermal cycling data (Hall and Sherry, 1986), it is found that creep is the predominant factor in deciding fatigue life. Creep accounts for 51 to 97 percent of the total accumulated strain energy, depending on the cycling profiles. This criterion is used to simulate crack propagation in a solder joint by analyzing the strain energy in small “domains” within the joint.

Copyright © 1994 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In